Support Forum

Archiv:
 
  • Sloped enclosure?

    Can you fabricate a sloped enclosure, similar to the Hammond 1456 series? Imagine something maybe 8" wide, perhaps 1.5" at the front (toward the user) and a 10- or 15-degree slope up so the back is higher? I would like the top and back to be at a right angle, making the angle between the bottom and the back 80 or 75 degrees depending on slope. The Hammond boxes have the bottom-to-back angle at 90 degrees.

     

    The idea is to mount a PCB from the top (sloped) panel with connectors coming out the back. Using the Hammond box with the 80-degree angle between the top and back means that I need one PCB for user interface (on the top) and a second to support the connectors through the back.

     

    Thanks!

    Posted By: Andy Peters on Jan 27, 2013 04:23AM Category: Front Panel Designer

  • 19" 1U Questions

    Hello I'm designing a 19" 1U rack enclosure. I'd like it 11" deep. I have the front and back designed. I found a template zip that I think is what I need. I can't seem to get the depth of the side/top and bottom panel correct. When I may them longer I can't get the screw holes to move with it. I'm not 100% I have the correct template. Any help is greatly appreciated.

    Posted By: Matt Sprigings on Jan 26, 2013 04:49PM Category: Front Panel Designer

  • 19" 1U Questions

    Hello I'm designing a 19" 1U rack enclosure. I'd like it 11" deep. I have the front and back designed. I found a template zip that I think is what I need. I can't seem to get the depth of the side/top and bottom panel correct. When I may them longer I can't get the screw holes to move with it. I'm not 100% I have the correct template. Any help is greatly appreciated.

    Posted By: Matt Sprigings on Jan 26, 2013 04:31PM Category: Front Panel Designer

  • Construction Lines

    I'm used to using construction lines as a way of lining up things so that they are straight. Is there a way to place construction lines?

     

    If not, how do you set a hole or other object to exact coordinates?

    Posted By: Dave VanHorn on Jan 23, 2013 06:45PM Category: Front Panel Designer

  • cleaning infill smudge

    I just received a panel that I'm pretty happy with but a few of the engraved letters have infill smudges. Is there a recommended solvent that can be used to clean this up without damaging the anodized finish?

    Posted By: David Moylan on Jan 18, 2013 05:02AM Category: Production

  • Beveled edge's

    Hello,

     

    I would like to make a front panel with rounded corners that has a 22degree bevel all the way around. is that possible? how do I calculate the cost of that??

    Posted By: Dave Meyers on Jan 17, 2013 02:25AM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+