Support Forum

Archiv:
 
  • Custom enclosure

    I am trying to build a rack mount enclosure that is about 20 inches long and I am working on the front panel now. How do I make the side and back panels to fit without using a template because none of the templates fit the size that I need?

    Posted By: Emily Gidcumb on Aug 30, 2010 08:44PM Category: Front Panel Designer

  • Logo JPG

    Hello,

    It is possible to incorporate a logo in JPG format to the designs of my panels?

    Best regards

    Josep

    Posted By: Josep Lopez on Aug 22, 2010 11:35PM Category: Front Panel Designer

  • saving files

    In previous version, it was possible to set the default location for saved files. I'd like to see this back.

    Also the Recent Files header is a bit sloppy. Why not put recently opened files directly at the bottom like most other software.

     

    Thanks

    Posted By: Dan Santoni on Aug 17, 2010 01:22PM Category: Whishes

  • Panel Color

    would it be possible to add white to the color selection. i sure would appreciate it.

    thanks,

    RH

     

    Posted By: Randy Humbert on Aug 13, 2010 04:21PM Category: Front Panel Designer

  • Panel Color

    would it be possible to add white to the color selection. i sure would appreciate it.

    thanks,

    RH

     

    Posted By: Randy Humbert on Aug 13, 2010 04:15PM Category: Front Panel Designer

  • hole size tolerances

    Hello,

     

    I'm wondering what the general tolerance is for hole sizes.

    I received an order today in which a few 0.125 inch were used, intended for press-fit dowel pins. The dowel pins are loose instead and I found that a #30 drill (nominally 0.128") passes easily through those holes.

     

    It would help me to know what precision to expect.

     

    I can just use slip-fit loctite for now, but in the future should I specify any special tolerance in the order notes (or elsewhere?), or have them drilled smaller and ream precision-diameter holes myself? I have low volumes so that wouldn't really be a problem for me either.

     

    Thanks,

    Ed Heitzman

     

    Posted By: Ed Heitzman on Jul 26, 2010 08:47PM Category: Production

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+