Support Forum

Archiv:
 
  • Cutout size question

    Square cutout question:
    If I have a b***on that is 10x10mm.
    What is the minimum cutout size I can make for it? Given that the minimum corner radius setting for a smooth square appears top be 0.5mm?

    Posted By: Tom on Jul 10, 2017 05:15PM Category: Front Panel Designer

  • mask off areas from being anodized

    I have a couple of panel mounted (single 5/8 in hole) antenna connectors which I would like to be electrically connected to the aluminum panel.

    Is it possible mask off anodizing at specific small areas on the rear of the panel?

    Posted By: Anthony Gainsborough on Jul 09, 2017 08:54PM Category: Front Panel Designer

  • Front Panel Designer will not start on Kubuntu 16.10

    I'm unable to get Front Panel Designer to start on Kubuntu 16.10 Front Panel Designer appears to be dependent on libpng12, which is a rather old version, so it fails to start. libpng16 is the current version. Anyone know a workaround? Can Front Panel Designer be recompiled so it will work with the current version of libpng?

    Thanks

    Stan

    Posted By: Stan Gammons on Jun 17, 2017 10:26PM Category: Front Panel Designer

  • Hole for press fit connection

    I am producing a panel that uses standard Schroff IEC 60297 style hardware. I have attached a file illustrating the hole I wish to specify in Front Panel Designer. Please help. Thank you.

    Attached File: Hole_Specification.png

    Posted By: Craig Drennan on Jun 13, 2017 06:05PM Category: Front Panel Designer

  • Custom cavity

    Hi,

    I'd like to create a cavity with an arbitrary shape. I see that you can create circles, rectangles, circles-in-rectangles, etc. I'd like to import a dxf and use that as the cavity. This obvious feature appears missing from the software.

    I searched on the forum and found one Customer Service Rep who said it can be done, here:

    https://www.frontpanelexpress.com/support/forum/?tx_wecdiscussion%5Bsingle%5D=308

    ...but there are no details about how to import dxf and "specify it should be a cavity". Do we import dxf as a cutout and then specify in the notes section when we order that that should be a cavity instead of a cutout? If so, how do we tell the human operator which cutout we are talking about (if there are several)?

    Thanks,
    David

    Posted By: David on Jun 11, 2017 06:57AM Category: Front Panel Designer

  • simple non rectangular front panel

    I would like to create a slightly non rectangular front panel shape. I've been looking into hand editing a .DXF, but haven't found any easy to follow examples. Could someone help me or suggest another way ?

    Gerrit

    Posted By: Gerrit Slavenburg on Jun 04, 2017 09:42PM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+