Support Forum

Archiv:
 
  • Rectangle in Rectangle Cavity

    I am designing for material that I plan to supply. The material is ~1.8mm thick and is powder coated. In the Designer Software I have selected 2.00mm thick since it gives an error when I select 1.5mm thick.

     

    I want to make a rectangular hole with a cavity surrounding it with a material thickness of 1.5mm. I assume the "Rectangle in Rectangle" option is the one I want to choose. However, I don't know which depth to specify. Should I select a depth of 0.5mm since I selected the 2.00mm material in the properties? or should I select a depth of 0.3mm since the actual material is 1.8mm?

     

    Edited: 2/23/12

    Posted By: Jason Meeusen on Feb 22, 2012 11:17PM Category: Front Panel Designer

  • 2-Way Radio Mounting Options

    I looked at the enclosure manual; but I'm still not 100% sure what I need to do to make this work.

     

    See the attached image.

     

    What I'm trying to do.. is make a face plate with a rectangle cutout that a CB radio will slide into. The radio has two holes/screws.. one on each side, midway down to secure it to the mounting bracket. Basically I need to make a piece that will attach at a 90 degree angle at the edge of the rectangle cutout on each side of where the radio will mount, to give me a place to put the screw (again, see image attached).

     

    What all do I need to do in the front panel designer to make this work? Just put a blind hole near the cutout? What about hardware, and the actual bracket? Assume it would need to be a bent,or welded L type bracket with a hole to mount?

     

     

    Posted By: Travis Howle on Feb 20, 2012 03:15PM Category: Front Panel Designer

  • dxf Adobe Illustrator Import

    Hi all

     

    Does anyone have any experience with a dxf Adobe illustrator import ?

     

    I can't import a Front Panel export's dxf file ! in Adobe Illustrator.

     

    I just would want to make the engraved text with Adobe.

     

    Thanks for your help.

     

    Anode

    Posted By: Ritchie Ritchie on Feb 19, 2012 06:24PM Category: Front Panel Designer

  • 2 wishes

    1. a template for a mother board base...

     

    2. a ruler placed on the sides of the project..

     

    great program...

     

    me

     

    Posted By: jeff inselberger on Feb 14, 2012 06:00AM Category: Whishes

  • Sub-D Connector for DVI Coupler

    I need help to create hole for DVI Coupler.

     

    Thank you,

     

    Greg

    Posted By: Greg Burakovsky on Feb 13, 2012 05:07PM Category: Front Panel Designer

  • conductive finish

    Do you offer an electrically conductive finish?

     

    Regards,

    Dave

     

     

    Posted By: David Davenport on Feb 11, 2012 04:37AM Category: Production

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+