Support Forum

Archiv:
 
  • Multiple grid Setup

    A way to set up multiple grids and a shortcut keys to switch between them.

     

    This can help work with a mix of inch and metric dimensions and I don't have to do the conversions. :)

     

    Plus it allows me to quickly change the grid for precision placement/adjustment.

     

    Or at least add a shortcut key to move the object half grid spacing.

     

    Posted By: Glenn Berden on Aug 30, 2011 09:27PM Category: Whishes

  • Ruller

    A dimension tool to measure between 2 points would be nice.

    I'm tired of counting the grid dots :wink:

    Posted By: Glenn Berden on Aug 30, 2011 09:21PM Category: Whishes

  • Construction Lines

    Construction lines would be a big help. These are lines that extend both direction as far as cyber-space allows and can be set to any angle. These can really help line things up or when using complex shapes. These lines don't need to be removed before sending the final - they are simply ignored. They should be of an off color, or settable by the user so they are not confused with other lines and are usually dotted.

     

     

    Posted By: Glenn Berden on Aug 30, 2011 09:19PM Category: Whishes

  • Attribute Layer

    Add a Attribute layer. ON this layer we can make all the same shapes and text as normal but it is not part of the production part. The info doesn't need to be sent with the file. This way I can mark gauge and meter face outlines to represent the overhang and space the actual meter will take up. I can also leave design notes and not worry about removing them before sending the panel.

     

     

    Posted By: Glenn Berden on Aug 30, 2011 09:15PM Category: Whishes

  • Blind side holes and tapping

    Is it possible for you to drill holes into a cut edge? For example, if I wanted some holes drilled into the edge of a panel, could you do that?

     

    It would be really useful for assembly.... Particularly if you could tap them as well.

     

    Thx.

     

    Chris.

    Posted By: Chris M on Aug 16, 2011 05:44AM Category: Front Panel Designer

  • Slot with rounded end

    I need to produce a slot that is open at the edge of a panel, has a specific length and ends in a rounded end with a radius the same as twice the width of the slot. It's as if the slot was cut using an endmill with the same diameter as the width of the slot. Is a hole on top of the end of the slot the best solution?

    Posted By: Carey Fisher on Aug 12, 2011 03:16PM Category: Whishes

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+