Support Forum

  • Side Profile 1 Dimensions

    I'm building an enclosure using the side profile 1 assemblies. I need a bit more information so I can determine the height of my circuit board within the enclosure. What are the dimensions C, D, E, and F in the drawing below? I cannot find this information in the enclosure manual. Thank you.



    Posted By: Glen Akins on Feb 21, 2010 06:33PM Category: Front Panel Designer

  • Templates for HiFi2000 Enclosures


    I'm building a project for which I will use two HiFi 2000 enclosures.

    The GX388 and the GX283.

    Do you have any templates for the front and rear panels please?



    Posted By: Andy Michael on Jan 24, 2010 12:24PM Category: Front Panel Designer

  • raw aluminum condition

    I have a panel to be made soon for which the exposed raw aluminum at the cut edges is unacceptable, so we will need to get them anodized afterward. So I selected the raw aluminum material in the software and was warned that you do not guarantee surface condition.


    Is the condition going to be good enough that I can buff out imperfections before anodizing, or am I better off ordering an anodized panel and having it stripped and re-anodized afterward?


    I don't need a polished surface, my buffing would end up with a brush finish if that makes a difference.


    Thanks in advance,


    Posted By: Ed Heitzman on Jan 12, 2010 08:40PM Category: Production

  • More Colours

    Hi, I've recently downloaded the software and done a few trial runs of the FPE software and am more than impressed.


    Since this is particular section is wish list I'd like to ask that purple or violet infil colour and/or anodisation be considered for possible future inclusion. This has become a standard colour for greywater systems and it's inclusion would please one of my customers.

    Posted By: David Sawtell on Jan 12, 2010 03:03AM Category: Whishes

  • Non Design Layer

    It will be of great aid to have a layer that can be hidden or visible that will not be used in the design by Front Panel, but will be used by designer for various uses.

    Example of use:

    To add comments or part numbers, instructions of functions etc, This can be used in the documentation for the design.


    Posted By: Jorge de la Paz on Jan 02, 2010 04:02AM Category: Whishes

  • Error when trying to create new Macro object...



    I am receiving the following error when trying to create a new Macro object.




    Can you provide any suggestions as to what I may be doing wrong?




    Posted By: Landon Solomon on Dec 31, 2009 03:40PM Category: Front Panel Designer

Please enter your message:

* = required field

Facebook Linked In Youtube Google+