Support Forum

  • Macros after update

    I just updated to version 4.5 and all my user macros have disappeared. How can I get them back. It was a large library and I would rather not have to design them all again.

    Posted By: Greg on Feb 10, 2016 08:09AM Category: Front Panel Designer

  • Front Panel Designer shuts down after error message, Elementary OS Linux

    FPD shuts down after giving the following errors:

    /builds/code/FrontDesign.wx/ThirdParty/wxWidgets/src/common/intl.cpp(273): assert "!m_initialized" failed in DoInit(): you can't call wxLocale::Init more than once

    [1] std::basic_stringbuf::~basic_stringbuf()
    [2] std::basic_stringbuf::~basic_stringbuf()
    [3] std::basic_stringbuf::~basic_stringbuf()
    [4] __libc_start_main


    03:44:16 PM: Cannot set locale to language "English".
    03:44:16 PM: locale 'en_GB' cannot be set.
    03:44:16 PM: Cannot set locale to language "English".
    03:44:24 PM: locale 'en_GB' cannot be set.

    I used the 64bit deb package and installed it with sudo dpkg -i path/to/package

    Posted By: Isaac Barbary on Feb 09, 2016 12:51AM Category: Front Panel Designer

  • Reverse side engraving cost

    Ctrl-K shows breakout prices. If we wanted to know cost of engraving text on rear of panel, would the additional cost just be the engraved letter charge, or is there an additional setup charge for engraving on the rear of the panel.

    Posted By: Mike on Jan 28, 2016 06:20PM Category: Ordering

  • Ruler

    Hi all,
    I'm just starting with FPD, and would like to know if there is a ruler somewhere, so you can measure between two holes or points.
    I saw this post " Posted By: etch11 on Apr 30, 2014 12:25AM " and the replay is that would be add in the next versions, running the latest version can I've miss the ruler, or is not yet implemented?
    Since it's high on demand maybe it could be in the next version?

    Posted By: Nuno on Jan 08, 2016 02:58PM Category: Front Panel Designer

  • 3D viewing in FrontPanel Designer

    I have just completed my design exported it into DXF but it does not produce a 3D image. I also cannot find a 3D image view in Front Panel Designer.

    Posted By: Jim Flower on Jan 04, 2016 08:51PM Category: Front Panel Designer

  • Material Choice for Boat Panel

    I have a client looking to replace a boat gauge panel (plastic) with with a brushed aluminum finish. Is there a aluminum/coating preferred for the marine environment.

    Posted By: Tom Dabney on Dec 29, 2015 02:15AM Category: Production

Please enter your message:

* = required field

Facebook Linked In Youtube Google+