Support Forum

Archiv:
 
  • milled surface of clear plex

    Would the surface that is milled in the clear plexiglas be somewhat opaque rather than clear after the milling? Is it smooth or does it have mill "bite" marks?

    Posted By: Jeff Wilson on Feb 27, 2012 05:18PM Category: Production

  • Powder coat thickness on inside cuts

    Hi,

    How much powder coat is deposited on the inside surfaces of holes or rectangles?

     

    Say I have a rectangular cutout that is .4" X 1", what will be the actual opening size after the powder coating?

     

    Thanks!

    Roger

    Posted By: Roger Foote on Feb 23, 2012 03:09PM Category: Production

  • Rectangle in Rectangle Cavity

    I am designing for material that I plan to supply. The material is ~1.8mm thick and is powder coated. In the Designer Software I have selected 2.00mm thick since it gives an error when I select 1.5mm thick.

     

    I want to make a rectangular hole with a cavity surrounding it with a material thickness of 1.5mm. I assume the "Rectangle in Rectangle" option is the one I want to choose. However, I don't know which depth to specify. Should I select a depth of 0.5mm since I selected the 2.00mm material in the properties? or should I select a depth of 0.3mm since the actual material is 1.8mm?

     

    Edited: 2/23/12

    Posted By: Jason Meeusen on Feb 22, 2012 11:17PM Category: Front Panel Designer

  • 2-Way Radio Mounting Options

    I looked at the enclosure manual; but I'm still not 100% sure what I need to do to make this work.

     

    See the attached image.

     

    What I'm trying to do.. is make a face plate with a rectangle cutout that a CB radio will slide into. The radio has two holes/screws.. one on each side, midway down to secure it to the mounting bracket. Basically I need to make a piece that will attach at a 90 degree angle at the edge of the rectangle cutout on each side of where the radio will mount, to give me a place to put the screw (again, see image attached).

     

    What all do I need to do in the front panel designer to make this work? Just put a blind hole near the cutout? What about hardware, and the actual bracket? Assume it would need to be a bent,or welded L type bracket with a hole to mount?

     

     

    Posted By: Travis Howle on Feb 20, 2012 03:15PM Category: Front Panel Designer

  • dxf Adobe Illustrator Import

    Hi all

     

    Does anyone have any experience with a dxf Adobe illustrator import ?

     

    I can't import a Front Panel export's dxf file ! in Adobe Illustrator.

     

    I just would want to make the engraved text with Adobe.

     

    Thanks for your help.

     

    Anode

    Posted By: Ritchie Ritchie on Feb 19, 2012 06:24PM Category: Front Panel Designer

  • 2 wishes

    1. a template for a mother board base...

     

    2. a ruler placed on the sides of the project..

     

    great program...

     

    me

     

    Posted By: jeff inselberger on Feb 14, 2012 06:00AM Category: Whishes

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+