Support Forum

Archiv:
 
  • help with side profile 2 case

    Hi

     

    I am designing a case for a VHF Transverter for amateur radio use.

     

    I will use side profile 2 - 56mm high

     

    Case will be 200mm x 250mm

     

    I can find the dimensions of the cavity on the cover panels ok but how do I insert those onto a panel

     

    I downloaded the templates but can't see where on the cover panels the slot information for the cavity is entered

     

    hope that makes sense!

     

    Simon

    Posted By: Simon Lewis on Feb 24, 2011 11:23AM Category: Front Panel Designer

  • Help with front / back panel and custom enclosure?

    I am sourcing and gathering parts for a PASS DIY build theese days, and found out about this place through some threads on a diy forum. If I can get the entire enclosure from here, that be best. I don't need to order from hifi2000 and then get another panel. Much better from one place. BUT, I have tried the panel designer, and I don't understand how to make a full enclosure....

     

     

    Posted By: Kenneth Rørås on Feb 22, 2011 01:17PM Category: Front Panel Designer

  • Anodizing and Engraving Filling Sequence

    When in the process is the anodizing done? If it's done prior to cutting, milling and drilling, then the edges will be raw. If it's done afterwards, then the edges will also be anodized.

     

    What about the filling of the engravings?

     

    BTW, I am planning black anodized, with white fillings.

     

    Thank you...

     

     

     

    Keith

    Posted By: Keith Mycek on Feb 21, 2011 08:35PM Category: Production

  • EPS file import

    For those of us using the Mac OS X platform, it seems that generating an HPGL file is quite tricky. It would be great if FPD could import vector EPS files or some sort of PostScript-based file. This would open up many design possibilities for Adobe users.

     

    Any other Mac/Illustrator users out there?

    Posted By: Seth Alder on Feb 10, 2011 12:07AM Category: Whishes

  • A rabbit cut around the outside edge of panel

    I am new to your tool and cannot figure out how to add a rabbit cut around the outside edge of the panel. This is needed to allow the front panel to slide into a slot on the rack assembly. The rabbit is about 1.27mm deep and 1.27mm wide.

    Posted By: Larry Grandstaff on Feb 04, 2011 08:54PM Category: Front Panel Designer

  • A rabbit cut around the outside edge of panel

    I am new to your tool and cannot figure out how to add a rabbit cut around the outside edge of the panel. This is needed to allow the front panel to slide into a slot on the rack assembly. The rabbit is about 1.27mm deep and 1.27mm wide.

    Posted By: Larry Grandstaff on Feb 04, 2011 07:55PM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+