I need this thread which is deeper than a standard thread and my plan was to tweak the major diameter until the minor diameter matched BSP standard then use the matching thread pitch and subsequently run a proper tap through it. Is there a way to do this without having to tap afterwards? Thanks!
Posted By: steve
on Sep 16, 2019 10:58PM
Category: Front Panel Designer
I'm trying to design an enclosure using "Side Profile 1" but the drawing in the enclosure manual doesn't have enough dimensions to locate the y-axis location of each slot. Is there a more detailed drawing that includes all the dimensions?
At a minimum I think I need the two dimensions "C" and "D" indicated in red in the attached file.