Support Forum

Archiv:
 

Front Panel Designer category

  • How do I engrave an arc segment

    Is it possible to engrave an arc segment. If so how do I do that in FPD?

    Posted By: Joe Ralston on Oct 06, 2015 10:15PM Category: Front Panel Designer

  • Free Contour and Os

    Trying to have a LOTUS logo milled. When I import the logo the O seems to have its center milled out as well. How do I address this?

    Also, does the mill tool simply follow the contour of the dxf lines, or mill out the entire area within each letter?

    Attached File: Untitled.png

    Posted By: Mike Spenard on Sep 24, 2015 04:39PM Category: Front Panel Designer

  • Switch Panel

    2nd picture

    Attached File: Harrison_Lathe_Switch_Panel.jpg

    Posted By: Howard Clerf on Jul 11, 2015 02:25AM Category: Front Panel Designer

  • Switch Panel

    Hi, I'm trying to duplicate the switch panel that is shown on the RH side of the attached picture. Is it possible you could do something like that?

    Attached File: Harrison_Lathe_Switch_Panel2.jpg

    Posted By: Howard Clerf on Jul 11, 2015 02:22AM Category: Front Panel Designer

  • arcs from engraved circles?

    I wish to have a means of creating an arc of a circle of less than 360 degrees (viz. the arc of a 320 degree Potentiometer)

    Posted By: John G. Gallagher on Jun 28, 2015 08:43PM Category: Front Panel Designer

  • Question on Housing profile 2 from a newbie

    For the Housing Profile 2, from the example , I can see the screw hole 'K' being specified on the Cover Panel pair 'B'.

    But I did not see the corresponding holes for 'K' on the Housing Profile 2 in the example.

    Are these hole required to be specified on the Housing probile 2 ? If so, how.

    Thank you.



    Posted By: Alan Tam on Jun 09, 2015 04:48PM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+