Support Forum

Archiv:
 

Front Panel Designer category

  • Side Profile 1 Dimensions

    I'm building an enclosure using the side profile 1 assemblies. I need a bit more information so I can determine the height of my circuit board within the enclosure. What are the dimensions C, D, E, and F in the drawing below? I cannot find this information in the enclosure manual. Thank you.

     

     

    Posted By: Glen Akins on Feb 21, 2010 06:33PM Category: Front Panel Designer

  • Templates for HiFi2000 Enclosures

    Hello,

    I'm building a project for which I will use two HiFi 2000 enclosures.

    The GX388 and the GX283.

    Do you have any templates for the front and rear panels please?

     

    Andy

    Posted By: Andy Michael on Jan 24, 2010 12:24PM Category: Front Panel Designer

  • Error when trying to create new Macro object...

    Hello!

     

    I am receiving the following error when trying to create a new Macro object.

     

     

     

    Can you provide any suggestions as to what I may be doing wrong?

     

    Thanks!

    Landon

    Posted By: Landon Solomon on Dec 31, 2009 03:40PM Category: Front Panel Designer

  • Acess Violation when using cut or copy

    So I went to use FPD this morning and I can not use the copy or cut command without an access violation message popping up in German.

     

    I have rebooted, removed, rebooted again, reinstalled, and I still can not get the FPD program to behave.

     

    Does anyone know how to fix this problem?

    Posted By: Nick Podolak on Dec 30, 2009 04:18PM Category: Front Panel Designer

  • Language selection?

    Hello,

     

    My copy of the software installed in what looks to be German. I did select English (US) during the install. Any suggestions on how to correct this?

     

    Thanks!

    Landon

    Posted By: Landon Solomon on Dec 22, 2009 08:35PM Category: Front Panel Designer

  • Language selection?

    Hello,

     

    My copy of the software installed in what looks to be German. I did select English (US) during the install. Any suggestions on how to correct this?

     

    Thanks!

    Landon

    Posted By: Landon Solomon on Dec 22, 2009 08:18PM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+