Support Forum

Archiv:
 
  • Stud and Standoff "Place on reverse side"??

    I want to place a thread M3 stud on the bottom plate to mount a PCB board on. I am confused about the option of "Place on reverse side". What does that mean if I put the check mark there? What does it mean if I uncheck the "Place on reverse side"?

    Posted By: Vu on Nov 11, 2016 04:33PM Category: Front Panel Designer

    Hello Vu,

    By default studs/standoffs are placed on the front of panels. If you want them on the back side of the panel select 'place on reverse side' and that will be indicated in the software with a diagonal hatching appearance.

    Posted By: Adrian on Nov 15, 2016 05:19PM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+