- 1:Front Panel Designer
What do I need to specify to make sure the clamp marks from the machining are removed from the sides of the panel. 4 mil and up panels seem to have deep clamp marks in them. I need to have them milled off.
Posted By: Mark Still on Sep 06, 2017 03:09PM Category: Production
Thank you for your message! Can you please send an Email to email@example.com with this question and pictures of what you are referring to?
This way our customer service team can properly address your concerns.
Thank you again,
Posted By: Brooke on Sep 07, 2017 01:14AMReply
Thank You. Will do
Posted By: Mark Still on Sep 07, 2017 04:14PMReply