Support Forum

Archiv:
 
  • XLR descriptions preferances

    choosing these xlr's to match was excruciating.
    What about more description in the preferences pain. Once on the layout there is no way to reference what one you chose.right clicking preferences turned up too little information..no descriptor or hole size or anything for reference after the fact, you are left guessing. I ended up printing them all out and then using calipers to try and figure out what is what by numbering them one to 12 on a paper.. love the service but the software is real week in a lot of other areas too.
    And the connector selection is so sparse i'm making most of mine up myself and its been years sins this is the same library of parts never updated.

    Posted By: Chaz on May 08, 2018 04:52AM Category: Whishes

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+