Support Forum

Archiv:
 
  • infill Cavity?

    Hello,

    I have a customer's logo that I would like to engrave and have in-filled black. Since the file is a DXF, the only way i can import it is as a cavity, which does not allow you to infill.

    Is there an alternate technique I could use?
    Thanks

    Attached File: Orb_Logo_Gray-v3.dxf

    Posted By: Brian Sparano on Nov 03, 2019 05:58PM Category: Front Panel Designer

    Hi Brian,

    Thanks for reaching out about your project. If you could email your DXF file to info@frontpanelexpress.com, I can take a look at it for you.

    Thanks.

    -Mike

    Posted By: Mike on Nov 04, 2019 05:56PM

    Reply

    Hi mike, it is attached above

    Posted By: Brian Sparano on Nov 04, 2019 08:32PM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+