Support Forum

Archiv:
 
  • Can I set the point where a threaded thru-hole starts being threaded ?

    Hello,

    I would like to know if it's possible within fpd to set the place at which the threading in a threaded thru-hole begins.

     

    As you can see the reason for this is that with standard thread orientation my XLR socket when fully screwed in is 125 degrees out of alignment. I am using a Vista OS so don't have access to the front panel designer help files.

     

    any help appreciated :)

    Posted By: Douglas Hunter on Mar 13, 2008 12:49PM Category: Front Panel Designer

    Hello Douglas,

     

    Unfortunately, setting the place where the thread starts is not possible.

     

    I would suggest that you just pick a drilled hole for the panel and use a nut to tighten the socket. In this way, you can assure that is has the right angle.

     

    Best Regards,

    Diane

    Posted By: Diane Haensel on Mar 13, 2008 09:36PM

    Reply

    Hello Diane,

     

    Your suggestion is a good one and should solve the problem.

     

    Thankyou for your help and the fast reply :)

     

    Fare well

     

    Douglas

     

    Posted By: DouglasH on Mar 14, 2008 05:57AM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+