
Support Forum
-
Cavity Example
Hello,
I'm entirely new to FPE and had a tiny question. Could you please give me an example of a cavity?A pic would be nice.
I have an LCD(50*40)mm which I need to put in a FP. The only way to hold the LCD in place is to create a cavity on the reverse side of the FP. This allows it to stay in place. I still have to support it from the reverse side, but I can take care of that.
Will a cavity do such a thing?
Posted By: Gerry S on Jun 18, 2011 08:05PM Category: Front Panel Designer
Hello Gerry,
Thank you for contacting us regarding cavities. Below is a photograph of a cavity placed on the front side of a panel with a rectangular hole placed in the middle, along with four through holes.
(Click to enlarge)
Let us know if we can provide any additional assistance.
Kindest Regards,
Paul Birkeland
Customer Service Manager
Posted By: Paul Birkeland on Jun 22, 2011 11:10PM
ReplyThanks Paul, but the image link does not work. Must have expired.
Posted By: Gerry S on Jul 21, 2011 03:30AM
ReplyThanks Paul, but the image link does not work. Must have expired.
The link should be back in working order.
Patric
Posted By: P Neumann on Jul 27, 2011 12:48AM
Reply