Support Forum

Archiv:
 
  • Bending

    Is it possible for a small panel to be bent so that I could order end panels for a small enclosure that provide a right angle mounting tab?

    Posted By: Michael Evinger on Jun 12, 2008 08:04PM Category: Production

    We do not do any bending at our facility. We just manufacture the flat panels.

     

    But if you like to consider a thicker material, e.g. 6mm, we can tap the side edges. Or you can use one of our extrusions (more here)

    Posted By: Diane Haensel on Jun 13, 2008 06:37PM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+