Support Forum

Archiv:
 
  • Small size cable glands

    Hello, please tell me how to make holes with thread, for PG7 and PG9 cable glands.

    Posted By: Zinaida Lyubimova on Mar 26, 2012 08:49PM Category: Front Panel Designer

    Hello Zinaida,

     

    Thank you for contacting us with your inquiry.

     

    The angle on PG threads is a little bit unusual in that it is 80 degrees, while most other threads are 60 degrees.

     

    We do not have an 80 degree threader in stock, but we can special order one if necessary. In Front Panel Designer, you would want to leave us notes in the Remarks for Production about which holes would require the special threader, then you could use the following settings below to get the correct object onto your panel:

     

    The PG7 threaded hole has the following parameters:

    Outer diameter: 12.5 mm

    Pitch: 1.27

     

    This can be inserted in our software using the UNF (Unified Fine) 1/2" - 20 thread.

     

    The PG9 threaded hole has the following parameters:

    Outer diameter: 15.2mm

    Pitch: 1.411

     

    This hole should be made by selecting the "manual thread parameters" in the drill hole properties, then entering a diameter of 15.2mm and a thread pitch of 1.411 mm.

     

    Do note that the PG thread standard has been considered obsolete for about a decade, and most cable glands should be available in standard metric threads.

     

    If we can provide any additional assistance, please do not hesitate to let us know.

     

    Kindest Regards,

    Paul Birkeland

    Customer Service Manager

     

    Posted By: Paul Birkeland on Apr 05, 2012 12:54AM

    Reply

    This is one of the highly attractive, informatics, well-written and highly crisp post that has been explained in fabulous manner to help out reader and visitors. All information found here is genuine and realistic. Thanks for sharing.

     

    cable glands | cable gland

    Posted By: Dom Smith on Apr 14, 2012 07:01AM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+