Support Forum

Archiv:
 
  • Combined parts

    I have 2 complimentary L-shaped parts. Is it allowable to submit them as a single "panel" separated by a cut? If so is the correct way of doing this using elongated shapes made with the hole tool?

    Posted By: ecurtz on Mar 18, 2013 07:31PM Category: Production

    Hello,

     

    here is a link to an old post. It has combined parts as well.

     

     

    Just give the L-shaped parts enough stability to not collapse during milling. I recommend a short "connector" of 10mm length all 120mm along the perimeter.

     

    Best regards,

    Diane

    Posted By: DianeHaensel on Mar 19, 2013 02:04AM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+