Support Forum

Archiv:
 
  • Printing problem

    I printed the 100% layout for checking the holes if they are matching with the components. I printed the file with three different printers. All printouts are around 10% smaller than the actual dimensions.

    Can anyone advise what may be the problem?

    Posted By: bigpanda on Dec 10, 2013 04:51AM Category: Front Panel Designer

    Hello,

     

    I am trying to rule out any printer driver issues. Could please print to a PDF file and then print this one? Same effect?

     

    Thank you,

    Diane

     

    Posted By: DianeHaensel on Dec 11, 2013 01:38AM

    Reply

    Likely your printer setup says "fit to margins" and your panel is close enough to the margins to cause the scaling to kick in.

    Posted By: STMRadio on Sep 16, 2014 05:38PM

    Reply

    I print a 19 inch 3U panel to 100% to check fit in fpd 6.01. All of the holes appear to have the correct dimensions and spacings; however, the panel itself comes out 19.5 inches by 5 3/8 even though the panel properties are correct. When I print out an 8U panel, dimensions match the panel properties. Do I have a setting off somewhere?

    Posted By: Ken on Sep 28, 2018 03:35PM

    Reply

    Hi Ken,

    Sorry you are having issues. Send your file to info@frontpanelexpress.com and I will try and print it on my end and see if I have this issue.

    Adrian

    Posted By: Adrian on Sep 29, 2018 01:15AM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+