Support Forum

Archiv:
 
  • Outline print extremely light

    When I print in outline mode at first I thought it was a blank page until I looked really close, then I could see the incredibly fine lines of the outline. Way too fine to be usable. Is there any way to thicken those even a little?

    Update: I turned off economode and got very fine lines, but at least I could see them. Enough to do a trial fit cutout.

    And of course can print in non-wire mode, using the panel color as the guide.

    Posted By: STMRadio on Sep 16, 2014 05:45PM Category: Front Panel Designer

    I can't reproduce this but will check with IT. I guess it is a printer setup issue but will let you know for sure when I know more.

     

    Thank you for reporting this to us.

     

    Kind regards,

    Diane

    Posted By: DianeHaensel on Sep 17, 2014 10:29PM

    Reply

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+