Support Forum

Archiv:
 
  • Acess Violation when using cut or copy

    So I went to use FPD this morning and I can not use the copy or cut command without an access violation message popping up in German.

     

    I have rebooted, removed, rebooted again, reinstalled, and I still can not get the FPD program to behave.

     

    Does anyone know how to fix this problem?

    Posted By: Nick Podolak on Dec 30, 2009 04:18PM Category: Front Panel Designer

  • Language selection?

    Hello,

     

    My copy of the software installed in what looks to be German. I did select English (US) during the install. Any suggestions on how to correct this?

     

    Thanks!

    Landon

    Posted By: Landon Solomon on Dec 22, 2009 08:35PM Category: Front Panel Designer

  • Language selection?

    Hello,

     

    My copy of the software installed in what looks to be German. I did select English (US) during the install. Any suggestions on how to correct this?

     

    Thanks!

    Landon

    Posted By: Landon Solomon on Dec 22, 2009 08:18PM Category: Front Panel Designer

  • ascii code for infinity

    i am trying to use the infinity symbol, and i type in the ascii code for infinity which i think is 236 and a wavy line appears, any ideas?

     

    H

    Posted By: hugo nicolson on Dec 20, 2009 06:00AM Category: Front Panel Designer

  • Order checking

    Hello,

     

    I am working on a panel that has two small acrylic windows. It's been a little time consuming, but I think I have them correctly sized. Is it possible to have you check my Perspex panels to make sure they will fit in the cutouts on the panel? If so, is there a charge? Thanks.

     

    Posted By: Greg Loskorn on Dec 14, 2009 05:31AM Category: Ordering

  • Curved text possible?

    Hello, I would like to place some text around the perimeter of a large (3.5") drilled hole, following the curve of the hole and spaced 1/4" or so away. Is there any way to do that, other than placing individual characters and rotating each one manually? Thanks.

    Posted By: Greg Loskorn on Nov 10, 2009 03:40AM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+