Support Forum

Archiv:
 
  • User Manual PDF?

    I am looking for the read me or user manual for this program I downloaded through the HBT site. Is a manual available and I am overlooking it or is it online somewhere? TIA for any direction you folks have.

    Bob

    Posted By: Robert Beckett on Oct 16, 2012 05:27PM Category: Front Panel Designer

  • Hole table import

    Would it be possible to add a feature where I can import a file in some format (for example, comma-separated value table) that contains X,Y coordinates for holes? Many panels I design require fairly a large number of holes and the possibility of making a mistake goes up when manually entering them.

     

    Ideally, I'd like to see the ability to read in a CSV table that has X,Y locations and hole attributes (diameter, threaded, countersunk) and the software will add these holes to the current design.

    Posted By: Jim George on Oct 15, 2012 06:48PM Category: Whishes

  • Shipping to Saudi Arabia

    Hi, I am a new user of front panel design and find it very usefull. I have few questions as follows:-

     

    1- I want to know if you ship the order to Saudi Arabia?

    2- I have designed two panels and i want to place a logo (TIF format) on the designed panels. Do i have to send you the logo file and mark the placement position of the logo on the design(s)

     

    Thanks

    Posted By: Uzair Ahmed on Sep 29, 2012 09:52AM Category: Ordering

  • D-SUB 9 CUTOUT

    Does anyone have a cutout template for a D-SUB 9 connector. I tried using the rectangular cutout, adding 10-degree corners but it is clearly not correct. Thanks.

    Posted By: John Lauf on Sep 27, 2012 12:34AM Category: Front Panel Designer

  • 19" Rack Panel System Holes

    I am designing a 6RU 19" rack panel. When I add the system holes, four holes appear in the four corners of the panel but I need to add more standard size rack holes on each side. Generally, a 6RU rack panel has four holes on each side and not just two. Ideas on how to add these?

     

    Paul

    Posted By: Paul Christensen on Sep 10, 2012 01:52PM Category: Front Panel Designer

  • Quality of panel back side finish

    I just recently received an order for an enclosure using the housing profiles. Everything appeared to be excellent until I flip the panels over and noticed everything from scratches to rub marks. In most cases this turned out not to be a problem. However on an inner enclosed area to save money, I did the cavities on the front side, thinking I could simply flip them over when I assembled it. Well luckily I had opted to use counter sunk screws on the outer main panels, so this required that I did the cavities on the reverse side, thus saving the day.

     

    Anyway I've had panels made before and never noticed such poor quality on the back side, nor have I seen anything mentioned about it in the FAQs or on this forum. Has something changed, or did I just get something that slipped through QC? As it turned out since this is only an issue with the flipped inner panels, it won't be apparent when the enclosure is fully assembled. But then again this was a very expensive project at nearly $1,400 and it caught me by surprise.

     

    So I guess my bottom line question is: Are there no guarantees on the finish quality for the panel back side, and/or is there an option to specify that both sides of the panel should have a high quality finish?

     

    Posted By: Michael St. Pierre on Sep 10, 2012 08:21AM Category: Production

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+