Support Forum

  • Change currency



    I wanted to order a few frontpanels but the program has the currency set to u.s. dollars.

    So far not a big problem but when I enter my address it tells me there is not shipping possible???

    I had this problem before on my laptop and I use my desktop to order then but after a reinstall it's on both my computers :(

    I live in the Netherlands and in the settings in Windows it also says Netherlands.

    I'm using Windows 8.1.



    Posted By: riktwi on Sep 19, 2014 04:59PM Category: Ordering

  • Outline print extremely light

    When I print in outline mode at first I thought it was a blank page until I looked really close, then I could see the incredibly fine lines of the outline. Way too fine to be usable. Is there any way to thicken those even a little?

    Update: I turned off economode and got very fine lines, but at least I could see them. Enough to do a trial fit cutout.

    And of course can print in non-wire mode, using the panel color as the guide.

    Posted By: STMRadio on Sep 16, 2014 05:45PM Category: Front Panel Designer

  • Potentiometer scale encraving

    Hi all people


    I am new here on this forum and also new Front panel designer user.

    First I would ask where I can find the tool to make on my front panel a scale for pots. same kind of engraving and painting as text.

    Maybe there isnĀ“t such a tool, or macro.. what ever it needs.


    It would be nice to have scale with numbers from 0 to 10 or just lines surrounding the knobs.



    Posted By: Eki_Electronic on Sep 09, 2014 08:35PM Category: Front Panel Designer

  • Small holes in cavity

    Hi, my 6mm thick panel has a large cavity that is about 5mm deep. I would like to place some 2-56 tapped holes in the cavity, which will only pass through the remaining ~1mm of material at the bottom of the cavity. However, FPD still thinks that the material is 6mm thick and will only let me tap a blind hole, 5.8mm deep. Is there any way to convince the program that the material is only 1mm thick at the location of these holes, so that it can tap them thru? The same restriction applies to regular holes less than 2mm diameter.

    Posted By: Mwalker on Sep 03, 2014 07:08PM Category: Front Panel Designer

  • 4.4 says -$0.99 for Shipping!

    :shock: That GREAT! ship 10 panels 4.7kg.

    UPS next day air service for -$1

    4.4 is not ready for prime time :wink:

    Posted By: VTXHOGG on Sep 03, 2014 02:32PM Category: Front Panel Designer

  • Another install error

    Trying to install the new FPD 4.4.0 but im getting an error:

    "Two packages provide the same file"


    This is on fedora 20 64 bit.


    Posted By: acidblue on Sep 02, 2014 10:25PM Category: Front Panel Designer

Please enter your message:

* = required field

Facebook Linked In Youtube Google+