Support Forum

Archiv:
 
  • Default measurement

    How can i let FPD using US measurements as default

    Posted By: Harry H. arends on Dec 13, 2017 04:29PM Category: Front Panel Designer

  • Copy & Paste Entire Design

    Hello,
    I am hoping to be able to print out multiple copies of an entire panel design on one sheet prior to ordering the final version, to test the fit and make sure I have the right measurements. In the past I have printed out one panel per sheet, but I would like instead to put 4 - 5 panels onto one sheet.

    So far I haven't been able to copy & paste at one time everything from the panel. How can I do this? Thanks

    Attached File: BAP.2.fpd

    Posted By: Richard Wood on Nov 24, 2017 03:02PM Category: Front Panel Designer

  • Front plate

    Can a front plate be angulated, i.e. not flat?

    Posted By: Stephen Zador on Nov 23, 2017 05:07PM Category: Production

  • no international shipping???

    I just spent hours and hours designing a panel and then realize there is no international shipping option available?

    Posted By: Jan on Nov 10, 2017 12:49PM Category: Ordering

  • engraving/printing

    I had some panels made 5 years ago and the engraving (with white infill) looked coarse and too deep, but shallower and thinner text did not show up as well.

    Can these people make a panel look silk screened? If not these people, who can make me panels about 2" x 5" inches with switch holes and legend beneath them?

    Posted By: Bruce Carlson on Nov 03, 2017 08:14PM Category: Front Panel Designer

  • PCB mounting 0.05" above the plate

    Hi,

    I have a design for a thermal cold plate which has several PCBs mounted 0.05" above the plate. In the previous production the mounting was achieved by having 4-40 threaded blind holes concentric with 4.6 mm circular cavities of 0.73 mm depth. A 2 mm spacer in each cavity defined 1.27 mm mounting height.

    I'd like to change mounting points to 4-40 studs with 5.08 mm depth offsets. That leaves 0.05" protruding part. My question is, what kind of variation can I expect on that height?

    Posted By: Dmitry Teytelman on Oct 24, 2017 03:24AM Category: Front Panel Designer

Please enter your message:

* = required field

  •   
  •   
 
  
Facebook Linked In Youtube Google+